Whirlpool T1400 Handbuch Seite 23

Tub does not
stop filling
Insufficient
washing
Insufficient
rinsing
Spots and shadows on
glassed and silverware
Insufficient
drying
Insufficient
steam condensate
Insufficient
Washing,rinsing
and drying
11
Burned electrovalve coil
Membrane broken or defective
Dirty air trap
Pressure switch broken or out of
calibration
Dtached pressure-switch tube
Plugged nozzles
Water temperature too low
Insufficient detergent
Detergent not suitable
Bad detergent dosing
Pump not functioning
Nozzles plugged
Dirty electrovalve
Inlet water pressure unsuitable
Boiler contains deposits Missing
wash/rinse divisory curtain
Water containing calcium and
magnesium
Hardness values not
7°/10°F Water contains
minerals (Fe,etc.)
Wash/rinse temperature too low
Defective motor, resistances, etc.
Air intake holes obstructed
Brightener doser inoperative
Brightener container empty
Air expulsion holes obstructed
Plugged filter battery
Cold water inlet closed
Dirty or interrupted electrovalve
Defective motor or
components
FOR STEAM DISHWASHERS
Steam shutter closed
Condensate discharger
obstructed
Steam electrovalve inoperative
Condensate recycling
Deposits on boiler coils and tubs
Insufficient steam pressure and
flow
Steam heating battery
plugged or defective drying
Replace
Replace
Clean
Replace
Reattach
Clean
Check temperature
Ask detergent
technicians to intervene
Replace
Clean
Clean
Check water circuit
Clean Position
Inspect and request intervention by
within
a specialized technician
other
Check
Check and replace
Check
Adjust or replace
Fill
Check
Clean
Open
Clean or replace
electrical
Check or replace
Open
Clean
Replace
Check
Clean
Check
Replace