Seagate std224000n Installationsanleitung Seite 9

Seagate DAT Drive Installation Manual
Factory-default settings for each switch are shown in
Figure 3 (only DDS-3 drives have switches S9 and S10).
These settings are described in detail on the following
pages.
Figure 3
Default dip-switch settings
S10 S9
OFF
ON
Reserved
(do not use)
OFF
ON
Note. The drive must be turned OFF then ON or a
SCSI Bus Reset must be received for switch settings to
take effect.
The default dip switch settings for this drive are listed
below:
•
SCSI ID 0
•
The drive reads or writes both MRS and non-MRS
4-mm media.
•
Parity checking is disabled.
•
DDS-DC data compression is enabled (applies only to
models that support data compression).
•
Seagate inquiry string is enabled.
•
Power-on self-test diagnostics are disabled.
If these default settings are appropriate for your computer
system and you do not need to enable SCSI termination
for this drive, then turn to "Mounting an internal DAT
drive" on page 10.
S7
S8 S6 S5 S4
Inquiry
DDS Pass- MRS
Parity
Self-test String through Mode
Disable Archive DDS-DC Disable MRS
Enable Seagate DDS Enable All
5
S3 S2 S1
SCSI ID Selection
SCSI ID
OFF 0
OFF OFF
ON 1
OFF OFF
OFF ON OFF 2
OFF ON ON 3
ON OFF OFF 4
ON OFF ON 5
ON ON OFF 6
ON
ON ON 7