Oregon PS250 Original Bedienungsanleitung Seite 27

OREGON® Cordless Tool System
POLE SAW MODEL PS250
• For long limbs (Fig 29), cut the end of
the limb first (1) to relieve pressure from
the limb, then prune closer to the trunk
(2)
FIG. 29
(1)
• Thick limbs (greater than 10 16 cm/4 in
in diameter) can splinter or pinch the
chain when making a single cut from
the top To avoid pinching or splintering
(Fig 30), first make one shallow relief cut
on the bottom surface of the limb (1),
then cut the limb all of the way through
from the top of the limb (2)
FIG. 30
(2)
(1)
AE 0414 - F/N 563398
• After most of the limb has been
removed, make one smooth cut near
the trunk (Fig 31)
(2)
OPERATING THE POLE SAW
FIG. 31
27