Using The Appliance - BOMANN cb 966 Bedienungsanleitung

6....-05-BS 1243_Staubsauber
GB
Overview of the Components
1 Cable
2 On/off switch
3 Carrying handle
4 Cable-winding key
5 Dust bag filling display
6 Hose connection
7 Vacuum hose
8 Handle for opening the dust bag
compartment
9 Dust bag compartment
• Insert the connection head of the suction hose (7) into the hose connector (6)
until it locks in place. To do so, please press the buttons simultaneously. In order
to release the hose again, please press the buttons once more on the connec-
tion head.
• Keep the buttons pressed down and then pull out the hose.
• Please insert the sections of the 2-part suction tube (10) into one another and
then attach them to the handle section.
• Then assemble the floor nozzle (11) and/or the accessories.
1. Unwind the length of cable (1) you require.
2. Insert the mains plug into a correctly installed safety socket (230 V, 50 Hz) and
then switch the machine on using the on/off switch (2).
3. Vacuum at a steady speed. There is no need to exert pressure.
4. Attention: pay attention to the range that can be covered with the cable length.
Cable winding device:
Pull out the cable (1) up to the maximum length indicated with the yellow mark.
Never pull the cable out up to the red mark as the cable winding can be damaged.
Said damages are not covered by the warranty.
Winding:
Press the cable (4) winding button and guide the cable. Hold the cable to avoid wrap-
ping.
Nozzle Attachment:
The nozzle attachment is located below the take-up device for the mains lead or
below the outlet filter.
40
22.10.2004
Start-up
10 Suction tube, 2-part
11 Floor nozzle
12 Hook on the suction tube (not
shown)
13 Parking assistance (not shown)
Accessories:
"2-in-1" nozzle (groove and brush nozzle)

Using the Appliance

11:02 Uhr Seite 40