Using The Appliance - BOMANN bs 971 cb Bedienungsanleitung

Using the Appliance

1. Fit on the accessory.
2. Unwind the necessary length of cable and insert the plug in
a duly installed 230V/50Hz protective contact socket.
3. Set the vacuum power with the vacuum power regulator.
4. Vacuum at a steady speed. There is no need to exert pres-
sure.

NOTE:
Pay attention to the range that can be covered with the cable
length!
Vacuum power regulator
Low vacuum power:
Medium vacuum power:
High vacuum power:
Cable winding device
Pull out the cable up to the maximum length indicated with the
yellow mark. Never pull the cable out up to the red mark as the
cable winding can be damaged. Said damages are not covered
by the warranty.
Winding
Press the cable winding button and guide the cable. Hold the
cable to avoid wrapping.
Telescope Vacuum Pipe
The height-adjustable vacuum pipe enables individual alignment
to your height.
• Unlock the coupling by pressing the key in the direction of
the arrow.
• Slide the vacuum pipe to the desired length.
• To lock the device, release the key until you hear it lock in
place.
Nozzle accessories

NOTE:
The accessories are to be found in the holder on the telesco-
pic tube.
Upholstery nozzle: For vacuuming upholstery, curtains
and in corners and crevices etc.
Groove and brush nozzle: „2-in-1" nozzle: When this is folded
together it can be used as a groove
nozzle. If you would like to use the
brush nozzle, pull the brush section in
the direction of the arrow until it locks
in place.
Floor nozzle: To clean carpets or smooth surfaces.
Releasing the nozzles: Pull these off while turning slightly.
05-BS 971 CB Neu.indd 33
For curtains and delicate fabrics
For long-pile velour carpets and
textile flooring
For sturdy rugs and floors
In order to facilitate control, the floor nozzle (9) is fitted with roll-
ers and can be adjusted to suit the circumstances.
Carpet: make sure that the brushes on the floor nozzle are
deactivated when cleaning carpets. If this is not the case, press
the lever on the floor nozzle forwards with your foot.
In order to vacuum even surfaces, for example, press the lever
back with your foot. This activates the brushes (you can tell
whether this is the case by checking that the brushes are visible
on the floor nozzle).
Air Slide
Open the air slide on the hose handle in order to regulate the
airflow or to clear any particles sticking to the nozzle.
Filter
Your machine has three filter systems. The traditional dust bag
system has been replaced by a transparent dust container. In
this, coarse dirt particles and tiny particles floating in the air are
swirled out of the suction air by the high speed of the air current.
The quantity of dust can be easily read off at any time on the
container, which is also very easy to empty.
The purchase of dust bags is no longer necessary.
Main Filter (in the Dust Container)
Once the dust level has reached the MAX mark on the dust con-
tainer, or the suction power of the vacuum cleaner is reduced,
please proceed as follows:
Emptying the Dust Container
Press the button to release the
dust container and remove it from
the vacuum cleaner.
•
•
Press the button on the side
of the container to empty its
contents.
Then close the flap of the
dust container again.
33
01.04.2010 10:24:04 Uhr