Description; Purpose; Overview; Safety - GreenWorks GD48BCB Bedienungshandbuch

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2

OVERVIEW

Figure 1 - 20.
Trigger
1
Lock-out button
2
Upper shaft
3
Auxiliary handle
4
Lower shaft
5
Guard
6
Cut-off blade
7
Trimmer head
8
Guard cap
9
Blade
10
Release button
11
Positioning hole
12
Hex wrench
13
Central knob
14
Cap
15
Lower support
16
Spool cover
17
Spool
18
Tab
19
Line exist hole
20
Wrench
21
Nut
22
Outer cup
23
Outer ring-nut
24
Inner cup
25
Angle transmission hole
26
Bump knob
27
Direction of roatation
A
Best cutting area
B
Dangerous cutting area
C
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
WARNING
English
3

INSTALLATION

Remove the battery pack from the machine before
installation.
Do not use accessories that are not recommended for this
machine.
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2

ATTACH THE GUARD

Figure 2.
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
screwdriver (not provided).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
5. Put the guard cap onto the guard.
6. Align the screw holes on the guard cap with the screw
holes on the guard.
7. Tighten the screws.
3.3

ASSEMBLE THE SHAFT

Figure 3.
1. Loosen the screw on the coupler.
2. Push in the release button on the lower shaft.
4
WARNING
WARNING
WARNING
WARNING
WARNING