Description; Purpose; Overview; General Power Tool Safety Warnings - GreenWorks G40PSF Bedienungshandbuch

EN
1

DESCRIPTION

1.1

PURPOSE

The product fitted with a cutting attachment mounted
on a pole to enable the operator to cut the branches
of standing trees but not intends for cutting woods as
normal chainsaw.
This appliance is not intended for use by persons
(including children) with reduced understanding, or lack
of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
1.2

OVERVIEW

Figure 1-20
Small lock-out
1
button
Lock-out button
2
Trigger
3
Pole saw handle
4
Collar
5
Extension pole
6
Pole saw head
7
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine
before use.
Chain cover lock
8
nut
Oil tank cap
9
10 Bar
11 Chain
12 Oil indicator
13 Chain lubricant
14 Chain cover
WARNING
WARNING
English
• If parts of the machine are damaged, do not use
the machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
3.2

ADD THE BAR AND CHAIN OIL

Examine the amount of oil in the machine. If the oil level
is low, add the bar and chain oil as follows.
Use bar and chain oil that is only for chains and chain
oilers.
The machine comes from the factory without bar and
chain oil.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt
enters in the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. A completely filled oil tank will last for 15 - 40
minutes operating time.
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.
3.3

FIT THE POLE SAW

Figure 2-3
1. Mount the pole saw head on pole saw handle to
achieve the standard length.
2. Slide the collar upwards.
3. Turn the collar clockwise to tight it.
3.4

EXTENSION OF THE POLE SAW

Figure 2-3
4
WARNING
IMPORTANT
NOTE
IMPORTANT