Turning The Power On; Using The Doremi Sheet - Roland VT-12 Bedienungsanleitung

Turning the Power On

* Once everything is properly connected (p. 6), be sure to follow the procedure below to turn on
their power.
Cautions about the power
• Power to this unit will be turned off automatically after 30 minutes have passed without any of its
buttons being pressed (including time that metronome is sounding), or 30 minutes have passed since
playback of a track has stopped .
• Before turning the unit on/off, always be sure to turn the volume down. Even with the volume turned down,
you might hear some sound when switching the unit on/off. However, this is normal and does not indicate a
malfunction.
• This unit is equipped with a protection circuit. A brief interval (a few seconds) after turning the unit on is
required before it will operate normally.

Using the DoReMi Sheet

By affixing the included DoReMi sheet to the pitch indicator, you can use the DoReMi indications
to check the names of the notes.
If you want to check the names of the notes when using movable "Do" solfege, affix the DoReMi
sheet with "Do" positioned at the note name of the tonic you're using.
DoReMi sheet
* Before using the DoReMi sheet, be sure to remove the backing paper and the blue protective
sheet.
1
Set the [VOLUME] dial to the minimum
position .
2
Hold down the [POWER] button until the
power turns on .
Before You Use the VT-12
ENG
DEU
FRA
ITA
ESL
POR
NLD
9