Tait TP9100 Ladeanweisungen Seite 14

For example, if the charger has firmware version 2.02.01
installed, the red LED flashes twice, then the green LED flashes
twice, and then the orange LED flashes once.
Charger compliance information
United States
This battery charger has been tested and found to comply with the
limits for a Class B digital device, in accordance with part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This battery
charger generates, and can radiate, radio frequency energy. If it is
not installed and used in accordance with the instructions, it may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur. If this charger
does cause harmful interference to radio or television reception
(which can be determined by turning the charger off and on), try to
correct the interference by:
■
Reorienting or relocating the receiving antenna.
■
Increasing the separation between the equipment and receiver.
■
Connecting the equipment into an outlet on a circuit different
from that to which the receiver is connected.
■
Consulting the dealer or an experienced radio/TV technician for
help.
Canada
This Class B digital apparatus complies with Canadian ICES-003.
14 Battery Charging Guide