Troubleshooting - Niko Touchscreen 2 Handbuch

Programming the touchscreen 2
• Add the touchscreen 2 at the beginning of the project.
• The touchscreen can display a maximum of 256 actions across 100 locations.
• Several touchscreens 2 used in one single installation cannot be programmed differently (except for access
control).
When you add the touchscreen 2 to the project of the installation via the programming software, all pre-programmed
actions will automatically be linked to the touchscreen.
The programming software allows you to create locations and link actions to each location. This will give you a better
overview of the home. If an action is not linked to a location, the software will link the action to a virtual location. When all
actions have been linked, click the touch icon to open the overview. In this overview, you can remove any actions that you
do not want to be displayed on the touchscreen.
Touchscreen 2 maintenance
Use a soft dry or slightly damp cloth to clean the touchscreen 2. Do not use detergents or other cleaning agents.

Troubleshooting

Problem
Nothing is displayed on the screen.
You cannot operate the installation.
54
Touchscreen 2
Possible cause
Communication error
Solution
Check whether network communication is
possible between the touchscreen 2 and the
connected controller.
Reset the touchscreen 2.
Use an unfolded paperclip to press the reset
button. There is no need to disassemble the
touchscreen 2.