Using Cooling Mode; Using Dehumidification Mode - Silvercrest 9000 BTU Bedienungs- Und Sicherheitshinweise

Note: The blank button on the
remote control has no function.
Set up the product as described
in the chapter "Setting up the
product".
Plug the mains plug
perly installed grounded power
socket. Do not use extension
leads or multi-plugs.
Point the remote control
direction of the signal receiver
and make sure that there are no
obstacles between the two com-
ponents.
Note: You can control the direc-
tion of the air flow by moving the
lever on the ventilation slots

Using cooling mode

Press the POWER button
to switch on the product. The
product switches on and the
display shows the pre-set /
20
last set temperature.
Press the MODE button
repeatedly until the mode indica-
tor shows COOL. The product
21
is now in cooling mode.
Now set the desired temperature
using the TEMP– button
TEMP+ button
ture range: 16 °C–31 °C). The
set temperature flashes on the
40 GB/IE
into a pro-
10
in the
11
Note: You can remove the hot air
25
outlet hose
operating in dehumidification mode.
.
2
28
24
/
26
(tempera-
27
display and is saved after
20
approx. 5 seconds.
Push the SPEED button
to adjust the fan speed. The fan
speed indicator
selected speed (HIGH or LOW).
To turn off the product, press the
POWER button
Using dehumidification
mode
from the product when
13
For instructions on how to drain
the integrated water tank, see
the chapter "Draining the water
tank" or "Using continuous water
drainage".
Press the POWER button
to switch on the product.
Press the MODE button
repeatedly until the mode indi-
cator shows DEHUM. The
21
product is now in dehumidifica-
tion mode.
Note: The temperature is auto-
matically set to approx. 2 °C
below the currently measured
room temperature and shown
on the display
20
The temperature cannot be set
manually in this mode.
23
shows the
18
.
28
28
24
.