Connection Of Speaker- And Power Cables X2400.2 - BRAX X 2400.2 Bedienungsanleitung

If a subwoofer is connected we recommend to use highpass control 20
as variable subsonic filter or to turn control 20 counter-clockwise to
15 Hz to get a subsonic filter.
Fig. 18
Switches are located at
the boottom of the
amplifier
Connection of speaker- and power cables X2400.2 / GRAPHIC EDITION
Fig. 19 4-channel mode
SPEAKER FRONT
SPEAKER FRONT
LEFT RIGHT
MONO
Fig. 20 3-channel mode with woofer stereo signal
SPEAKER FRONT
SPEAKER FRONT
LEFT RIGHT
MONO
Fig. 21 3-channel mode with woofer mono signal
SPEAKER FRONT
SPEAKER FRONT
LEFT RIGHT
MONO
INPUT SPEAKER REAR
R
SPEAKER REAR
LEFT RIGHT
L
MONO
INPUT SPEAKER REAR
R
SPEAKER REAR
LEFT RIGHT
L
MONO
INPUT SPEAKER REAR
R
SPEAKER REAR
LEFT RIGHT
L
MONO
Fig. 18 Mono-Stereo Selector
To set the operating mode of the amplifier.
Position 1 - STEREO: If the amplifier operates in 4-channel mode the switch
has to be set on "stereo" (1) position and both inputs (1 and 2) are used.
Position 2 - MONO/BRIDGED: If the amplifier is operated in mono mode
with the front and rear channels the switch of either channel has to be set to the
„Bridged-Stereo" position (2). In this mode both channels work as one (Mono
Rear or Mono Front). In position „Bridged-Stereo" both inputs (1 and 2)
of either bridged channel pair must be used.
Position 3 - BRIDGED-MONO/CHR: As on position „BRIDGED-STEREO"
the amplifier operates in Mono mode where both channels work as one (Mono)
channel. In position „BRIDGED-MONO/CHR" only input L (2) is used.
This is necessary when only one mono signal is available.
Fig. 22 2-channel mode with woofer stereo signal
SPEAKER FRONT
SPEAKER FRONT
LEFT RIGHT
MONO
Fig. 23 2-channel mode with woofer mono signal
SPEAKER FRONT
SPEAKER FRONT
LEFT RIGHT
MONO
Important!
Never connect the speaker cables to the vehicle chassis. This can
destroy your amplifier. Ensure that all the speaker systems are con-
nected in-phase, i.e. plus to plus and minus to minus.The positive ter-
minal is indicated on most speakers. In addition, the amplifiers may be
operated in the stereo(see Fig. 22 / 23), 3-channel (see fig. 20 / 21) and
4-channel modes (see Fig. 19).
The mono/stereo selector switch is located at the bottom and can be
operated once the metal cover has been removed.The function of the
switch (stereo or mono) is described on a label at the bottom of the
amplifier (see fig. 18)
14
INPUT SPEAKER REAR
R
SPEAKER REAR
LEFT RIGHT
L
MONO
INPUT SPEAKER REAR
R
SPEAKER REAR
LEFT RIGHT
L
MONO