Not Permitted; Organisational Measures And Safety; Initial Operation - Prolux Mini Power 7 Multi Booster Originalbetriebsanleitung

Original operating instruction – Mini Power 7 Multi Booster
NB: Only the included mains chargers may be used to charge the Startbooster.
There is a risk of fire and explosion when using other mains chargers.
Never load or unload the Startbooster unattended.

Not permitted

- Do not expose the Startbooster to direct sunlight and extreme heat (> 70°C).
- The Startbooster must not come into contact with liquids or moisture.
- The Startbooster must not be used in the vicinity of explosive substances such as petrol, gas or dust.
- The booster must not be exposed to strong shocks (e.g. by falling down).
- The Startbooster must not be connected to a 12 V vehicle battery when the "24 V" button is pressed.
- The Startbooster must not be connected to a 24 V vehicle battery when the "12 V" button is pressed.
- The two battery tongs must never touch each other.
- Do not make more than three consecutive start attempts. After the third attempt, follow the instructions
under "Failed external start attempt".

Organisational measures and safety

- The Startbooster may only be used by qualified persons. This product is not suitable for use by children and
must therefore always be kept out of the reach of children.
- Always ensure that all cables and adapters are properly connected and securely fastened.
- The battery tongs must be removed from the vehicle battery within 30 seconds of a successful start.
- Before starting, check that the poles of the vehicle battery are free of dirt and rust. Dirty or rusty
battery poles must be cleaned before using the Startbooster.
- The standby time of the fully charged Startbooster is three to six months. However, we recommend
that you charge the battery of the Startbooster at least every two months to ensure that it always
functions properly.
- Only charge the Startbooster battery in a temperature range between 0°C and 40°C.
- The built-in lithium polymer battery should be stored in a cool place (between 15°C and 20°C). Storage in the
vehicle is not recommended.
- Avoid contact with battery fluid. In the event of skin contact with battery fluid, rinse the affected areas
thoroughly with clean water and contact a doctor.

Initial operation

a. Controls:
„TEST" Button:
Press this button to display the battery level and unlock the unit.
Selection of the output voltage:
Use the two "12 V" and "24 V" keys to manually select the number of volts for the jump start procedure.
If the "12 V" button is pressed, the LED indicator goes on and only vehicles with an on-board voltage of 12 V
may be started externally.ly vehicles with an on-board voltage of 24 V may be started externally.
If the "24 V" button is pressed, the LED indicator goes on and only vehicles with an on-board voltage of 24 V
may be started externally.
b. Charge the Startbooster:
1. Connect one of the included AC chargers to a suitable power source.
2. Connect the mains charger to the 14V 1A connection with the device.
NB: Only charge the Startbooster battery in a temperature range between 0°C and 40°C.
c. Battery charge indicator:
Press the "TEST" key to display the battery level of the device.
The charge indicator consists of a row of five separate LED lights.
7
English