Assembly And Use - Kenwood AT340 Anleitung

assembly and use

1 Remove the high speed outlet cover
.
2 Fit the gearbox assembly onto the
mixer .
3 Push the desired cutting plate onto
the shaft . Each plate is numbered
for identification and the number
should be uppermost when the
plate is pushed onto the shaft.
4 Fit the sweeper onto the shaft
with the flat surface of the sweeper
against the plate.
●
For best results when using the
slicing/chipping plates, the sweeper
arm should be positioned opposite
the blade, as shown below.
5 Attach the lid assembly to the body,
line up the
with on the body. Then turn to
symbol to lock into place
6 Fit the assembled attachment onto
the gearbox and turn to lock into
position .
7 If required fit the extension chute
into the food outlet and push firmly
into place . The extension chute
MUST be fitted when the
attachment is used with mixer
KM070 but can also be used with all
other mixers to direct the food into
the collecting bowl.
8 Connect the mixer to the power
supply and place a bowl under the
food outlet.
9 Choose which feed tube you want
to use. The pusher contains a
smaller feed tube for processing
individual items or thin ingredients.
To use the small feed tube -
first put the larger pusher inside the
feed tube .
To use the larger feed tube -
use both pushers together
10 Put the food inside the feed tube.
,
symbol on the lid
.
.
11 Switch the mixer onto speed 3 and
at the same time push down evenly
with the pusher – never put your
fingers in the feed tube.
●
At the completion of the processing
operation, raising and lowering the
pusher several times may help to
reduce the amount of food left on
the cutting plate.
12 Switch off and unplug.
hints
●
Always use fresh ingredients
●
Don't cut food up too small. Fill the
width of the large feed tube fairly
full. This prevents the food from
slipping sideways during processing.
Alternatively, use the small feed
tube.
●
When using a chipper plate, place
thin ingredients horizontally.
●
When slicing or shredding, food
placed upright comes out shorter
than food placed horizontally.
cleaning
●
Always switch off and unplug before
removing the attachment from the
kitchen machine.
●
Dismantle the attachment fully
before cleaning.
●
For easier cleaning always wash the
parts immediately after use.
●
Handle the cutting plates with care –
they are extremely sharp.
●
Never immerse the gearbox
assembly in water or allow it to get
wet.
All remaining parts can be washed
in hot soapy water, then dried
thoroughly. Take care as the cutting
plates are sharp. Alternatively wash
in the dishwasher (top rack only),
4