Aligning The Device - Waldmann Linura LTS/ST Gebrauchsanweisung

Mounting
Mounting the holders
Fig. 4: Mounting the holders.
X Place the holder B on the side part
such that the detent lug is located in
the groove of the side part and the
holder locks into place in the side part,
see Fig. 4.
X Mount the second holder to the oppo-
site side part of the device such that the
two holders are aligned in parallel to the
mounting surface.
Mounting the device to the fastening
elements
Fig. 5: Mounting the luminaire to the fasten-
ing elements.
X Place the device together with the
mounted holders onto the fastening ele-
ments and press the device downward
until the holders snap into the fastening
elements, see Fig. 5.
3.3

Aligning the device

After mounting, you can align the device.
The holders are provided with detent lugs
that engage with teeth on the side parts of
the luminaire.
The angle of the device can be adjusted in
small steps over a range of 120°. There are
additional detent points at -90° and +90°,
to align the device in exactly these angles.
NOTE: The device is only securely fastened
if the detent lugs of the holders are located
in the area of the teeth on the side parts.
B
-60°
Fig. 6: Aligning the device between -60°
and +60°.
+90°
Fig. 7: Aligning the device at -90° or +90°.
X Turn the device at an angle between
-60° and +60°, see Fig. 6.
or
X Turn the device to an angle of exactly
-90° or +90°, see Fig. 7 .
ENG
+60°
−90°
25