Control Reference Guide - Technics ST-C700D Bedienungsanleitung

Control reference guide

This unit
∫ Front
  
1 Power switch lever [Í/I (Standby/on)]/[OFF]
Turn on/off this unit.
≥ The remote control do not operate when the power switch
lever is in the lowered position.
≥ You can switch the unit from on to standby mode or vice versa
when the power switch lever is in the raised position. (
2 Port for iPhone/iPad/iPod and USB devices
( DC 5 V 2.1 A) ( 17, 18)
3 Remote control signal sensor
Distance: Within approx. 7 m directly in front
Angle: Approx. 30o left and right
4 Display
≥ The input source, playback status and other information
are displayed. For more details, check the support site
below as well as these operating instructions.
www.technics.com/support/
5 Basic control switches
These switches work just by touching the marks. Each
time you touch the switch, there will be a beep sound.
( 11)
≥ When playback information is not shown on the display
(except in NFC registration standby mode (
perform the following operations on the touch panel:
:
9
1/;
∫
HOME (Touch and hold)
6 NFC touch area ( 21)
The NFC touch area sheet is attached to this area at the
time of purchase.
  
8)
21)), you can
3 (Up)
4 (Down)
OK (OK)
RETURN (Return)
MENU (Enter menu)
∫ Rear
   
7 Product identification marking
The model number is indicated.
8 DAB/FM terminal ( 10)
9 Analogue audio output terminal [LINE OUT] (
: Digital audio output terminal [COAX OUT] (
; Digital audio output terminal [OPT OUT] (
< Digital audio input terminal [PC] (
For connecting to a PC, etc.
= System terminal [CONTROL] (
> LAN port [LAN] ( 12)
? AC IN terminal [AC IN T] (
Class II equipment
(The construction of the product is double-insulated.)
    
9)
9)
9)
20)
9)
) ( 10)
(7)
7