Technics ST-C700D Bedienungsanleitung Seite 28

Remote control code
When other equipment responds to the supplied remote
control, change the remote control code.
≥ The factory default is "Mode 1".
Point the remote control at this unit, and press
and hold [OK] and the numeric button for at least
4 seconds.
≥ When the remote control code is changed, the new code
will appear on the display for a few seconds.
[OK] + [1] Set the code to "Mode 1"
[OK] + [2] Set the code to "Mode 2"
≥ When the SU-C700/SL-C700 is connected via the system control
function, change its remote control code as well as the remote
control code for this unit.
Changing the character
encoding
You can change the character encoding of track names,
artist names and other information when they are not
displayed as they should be.
≥ The factory default is "Type 1( 日本 )".
1
Press [NWP].
2
Press [HOME].
3
Press [3, 4] repeatedly to select "SETUP"
and then press [OK].
4
Press [3, 4] repeatedly to select "E Asian
Character" and then press [OK].
5
Press [3, 4] to select
"Type 1( 日本 )"/"Type 2( 简体字 )" and then
press [OK].
Type 1( 日本 )
Type 2( 简体字 )
28
(28)
Priority is given to Japanese.
Priority is given to Chinese
(Simplified).
Using the system control
function
You can automatically link this unit with the SU-C700 and
operate them easily with the remote control.
Preparation
1 Connect this unit and the SU-C700 with a system
connection cable and a coaxial digital cable. (
2 Set the power switch lever of this unit and the SU-C700
to the [Í/I] position.
∫ Switching this unit and the SU-C700 to
on/standby simultaneously
≥ If you point the remote control at this unit and press
[NWP Í] when this unit and the SU-C700 are in standby
mode, this unit and the SU-C700 will be turned on
simultaneously.
≥ When both this unit and the SU-C700 are turned on and
the input source of the SU-C700 is set to "COAX1", you
can set them to automatically enter standby mode using
the sleep-timer. ( 26)
∫ Switching the SU-C700's input source
automatically
When you perform an operation such as playback on this
unit, the input source of the SU-C700 will be automatically
switched to "COAX1".
∫ Adjusting Bass/Middle/Treble
You can adjust the tone of the SU-C700 with this unit. Each
tonal range (Bass/Middle/Treble) can be adjusted.
1 Press [NWP].
2 Press [HOME].
3 Press [3, 4] repeatedly to select "SETUP" and then
press [OK].
4 Press [3, 4] repeatedly to select "Tone Control" and
then press [OK].
5 Press [3, 4] to select "On (adjustment)" and then press
[OK].
6 Press [3, 4] to select "BASS" (Bass), "MID" (Middle) or
"TREBLE" (Treble).
7 Press [2, 1] to adjust the level and then press [OK].
≥ Each level can be adjusted between "s10" and "r10".
≥ For information on the operations of the SU-C700, please also
refer to its operating instructions.
9)