Werbung
Verfügbare Sprachen
Verfügbare Sprachen
p p r r o o b b l l e e m m
The whisk or K-beater knocks against the bottom of the bowl or isn't
G
reaching the ingredients in the bottom of the bowl.
solution
Adjust the height using the spanner provided. Here's how:
G
Unplug the appliance.
1
Raise the mixer head and insert the whisk or beater.
2
Lower the mixer head. If the clearance needs to be adjusted, raise the
3
mixer head and remove the tool. Ideally the whisk and K-beater should be
almost touching the bottom of the bowl
4 Using the spanner provided loosen the nut
adjustment of the shaft
bowl, turn the shaft anti-clockwise. To raise the tool away from the bottom
of the bowl turn the shaft clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the mixer head. (Check its position see
points above).
7 Repeat the above steps as necessary until the tool is set correctly. Once
this is acheived tighten the nut securely.
problem
G
G
G
G
G
.
sufficiently to allow
. To lower the tool closer to the bottom of the
s e
c
in
m
Werbung
