Drawing From A Barrel; Nozzles - Wilks USA TX625i Bedienungsanleitung

English
TX625i

Drawing from a barrel

First ensure the machine is switched off before connecting / disconnecting any hoses or attachments.
Instead of attaching the hose from pump to tap, use the supplied hose and filter set placing the filter end
in the water supply.
It is advised that the water supply is on the same level as the washer. If you struggle to get initial suction,
remove the outlet hose from the pump and try drawing again - this reduces the pressure on the pump
making it easier to draw. Once flowing, turn engine off and reconnect outlet hose before re-starting.

Nozzles

Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5
0°Nozzle (Red) Fig 1 - This nozzle delivers a pinpoint stream of pressurized water and is extremely
powerful. It should only be directed at surfaces that can withstand high pressure such as metal or
concrete.
15° Nozzle (Yellow) Fig 2 - This nozzle delivers a powerful 15-degree spray pattern for intense cleaning
of small areas. This nozzle should only be used on areas and materials that can withstand very high
pressure.
25° Nozzle (Green) Fig 3 - This nozzle delivers a 25 degree spray pattern for intense cleaning of larger
areas. This nozzle should only be used on areas that can withstand very high pressure.
40° Nozzle (White) Fig 4 - This nozzle delivers a 40-degree spray pattern and a less powerful stream of
water. This nozzle can cover a wide area and can be used for most general cleaning jobs.
Detergent Nozzle (Blue/Black) Fig 5 - This nozzle is used to apply detergent and cleaning solutions.
This nozzle produces the weakest pressure of the three nozzles.
© Wilks-USA 9