Connect The Speakers - Pioneer X-HM76D Bedienungsanleitung

> Before Start > Part Names

Connect the Speakers

1
X-HM86D only
a
a
a
3
Install
a Non-Skid pads, b Speaker cable
> Install
2
a
RED RED
RED
b
b
> Initial Setup > Playback
4
RED
Supplementary information | Advanced Setup | Others
When connecting the speaker system for X-HM76D, X-
HM76 or X-HM86D, connect the included speaker cables
with ends with the red tubing attached to the i jacks on the
main unit and the speaker. If connection is wrong, the phase
reverses and this makes it harder to output bass.
For XC-HM86D, use the illustration as a reference to
connect your own speakers.
After inserting the speaker cables, tighten the terminals
firmly by turning to the right. Also make sure the exposed
wires of the speakers do not stick out of the speaker
terminals when connecting. If the exposed wires of the
speakers touch the rear panel or the i and s wires touch
each other, the protection circuit may be activated and the
power may turn off.
You can also connect a subwoofer with a built-in amplifier to
boost bass playback even more. Use a subwoofer cable for
connection.
E
N
11