B) Power (On / Off); C) Led Lights; Attachments; A) Insert / Remove Bits - BASETech 2147830 Bedienungsanleitung

b) Power (on / off)

1. Set the required direction of rotation by sliding the rotation switch (13).
2. Squeeze the ON/OFF switch (12) to turn the power ON, release to turn the power OFF.
Lock the switch in the off position by sliding the rotation direction switch (13) to the middle.

c) LED lights

The LED lights (14) will light up each time you squeeze the ON/OFF trigger.

10. Attachments

Make sure attachments are securely fitted before using. Both attachment release buttons (17)
properly locked in to prevent the attachment from coming off during use.
using any attachments.

a) Insert / remove bits

The multi tool is equipped with a bit attachment
point (16).
1. Lock the trigger in the off position by sliding
the rotation direction switch (13) to the
middle.
2. Insert / remove the bit from the attachment
point
b) Connect / remove
attachments
1. Lock the trigger in the off position by sliding
the rotation direction switch (13) to the middle.
2. Press both attachment release buttons (17) at the same time, then remove the attachment.
3. Insert a different attachment and make sure it is correctly installed before use. It should "snap" into place.

c) Offset attachment

The offset attachment (7) permits working near edges, walls, and difficult to reach places.

d) Right-angle attachment

The Right-angle attachment (8) permits working near edges, walls, and difficult to reach places.
28
should be
Fit the rubber cap (15) when not