Battery; A) Recharge; Status Led; Operation - BASETech 2147830 Bedienungsanleitung

8. Battery

a) Recharge

As power supply, only use the supplied mains adaptor. Do not use a USB port of a computer, keyboard or
USB hub without a power adapter as the current supplied by these ports is insufficient.
1. Connect the power adaptor micro USB plug (10) to the Micro USB input (11) on the multi tool.
2. Disconnect the power adaptor from the multi tool when charging is complete.
b) Status LED
Check the battery levels by:
1. Setting the rotation direction switch (13) to the central "lock" position.
2. Squeeze and hold the ON/OFF trigger (12). The LED status indicators will show the battery level.
All LED's on indicate the battery is fully charged.

9. Operation

Always protect against accidental starts. Before connecting / removing bits or attachments, lock the trigger
in the off position by sliding the rotation direction switch (13) to the middle. Always check to make sure a bit
is properly inserted before using the tool.

a) Trigger lock / change direction of rotation

You can lock ON/OFF trigger in the off position or change the direction of rotation as follows:
Clockwise rotation
Top view
Trigger is locked (OFF)
Tri
Anti-clockwise rotation
27