Before Using For The First Time - ROWENTA COMPACTEO ERGO RO5255GA Handbuch

14.a – HEPA filter cassette* (ref. ZR0045 01), suita-
ble for paper bags
b – HEPA filter cassette* (ref. ZR0042 01), suita-
ble for textile bags*
Your vacuum cleaner is fitted with either a micro-
filter* or a HEPA filter cassette*.
15. Bag support for Wonderbag Compact* (17c),
paper bag* (17a) or textile bag* (17b)
16. Bag support runners
Standard accessories:
17. Bags
a – Paper bag* (ref. ZR0039 01)
b – Textile bag*
c – Wonderbag Compact bag* (ref. WB3051)

3. BEFORE USING FOR THE FIRST TIME

UNPACKING
• Unpack your appliance, keep your warranty card and read the instructions for use carefully before
using your appliance for the first time.
TIPS AND PRECAUTIONS
• Before each use, the cord should be unwound completely.
• Make sure that it does not get stuck or go against any sharp objects.
• If you are using an extension cord, make sure it is in perfect condition and that it suitable for the power of
your vacuum cleaner.
• Your vacuum cleaner is fitted with a device to protect against the motor overheating. In certain cases,
(using the flexible hose on chairs, etc.) the device is triggered and the appliance may make an unusual
noise. This is of no consequence.
• Do not move the vacuum cleaner by pulling on the cord, the appliance must be moved by its carrying
handle.
• Do not use the cord to lift the appliance.
• Never unplug the appliance by pulling on the cable.
• Never operate without a vacuum bag and without a filtration system: microfilter * or HEPA filter cassette*.
• Ensure that the filter (13 or 14a and 14b) is firmly in place.
• Use only original Rowenta bags and filters.
• Use only original Rowenta accessories.
• In the event that you find it difficult to obtain accessories and filters for this vacuum cleaner, contact the
Rowenta customer service.
• Stop and unplug your vacuum cleaner after each use.
• Always stop and unplug your vacuum cleaner before maintenance or cleaning.
4. USE
ASSEMBLAGE OF THE PARTS OF THE APPLIANCE
• Push the flexible hose (18) securely into the suction opening (10) and turn until it locks - fig.1.
• To remove, turn in the opposite direction and pull - fig.2.
• If your vacuum cleaner is equipped with the telescopic tube * (19): push the adjustment knob forward,
pull the desired tube length out then release the button to lock – fig. 3a. Slot in the extension tube* (27) if
necessary. Otherwise, assemble the two tubes* (20), turning them slightly – fig. 3b.
• Fit the desired accessory to the end of the tube:
- For rugs and carpets: Use the all floor tool attachment (22) in retracted brush position – fig. 4.
- For parquets and smooth floors: Use the all floor attachment (22) in brush position – fig. 4.
or use the hardfloor tool* (21) directly.
- For corners and areas which are difficult to reach: use the slot tool attachment convertible
into a brush* (24) in the flat tool attachment position.
- For upholstery and delicate surfaces : use the crevice tool convertible into brush* (24) or the upholstery
nozzle* (23), or the brush integrated to the nozzle 18b* (depending on model).
* According to model: these systems are specific to certain models or are accessories available as an option.
18 a. Flexible hose with nozzle, mechanical
power control*
b. Flexible hose with nozzle, mechanical
power control, and integrated brush*
19. Telescopic tube*
20. Tubes*
21. Hardfloor tool*
22. All floor tool
23. Furniture tool*
24. Slot tool attachment convertible into a brush*
25. Turbobrush *
26. Mini turbobrush*
27. Extension tube*
EN
7