Beta 560/C3 Gebrauchsanweisung Seite 4

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
TORQUE MULTIPLIER, RATIO 3,8:1 (1500NM) / 3,8:1 (2700NM)
IMPORTANT NOTICE: The multiplication factor 3,8:1 means that the input torque is multiplied 3,8 times
out of the multiplier.
CAUTION: Torque multipliers must always be used with torque wrenches;
no impact wrenches may be used.
ART. 560/C3
ART. 560/C3PLUS
4
Set the torque wrench according to the required tightening
value; and mount the required socket. Place the multiplier
on the hexagon, rotating it by hand until the reaction foot or
lever firmly stands on a wall/nut etc.
Fit the male square of the torque wrench into the female
square of the torque limiting socket (A), which will not allow
maximum input torque to be exceeded.
The torque limi¬ting socket will break if maximum input
torque is exceeded, thus preventing the multiplier from
being dama¬ged. Then fit the torque limiting socket into
the female square of the multiplier and tighten as much as
needed.
As the forces accumulated inside must be released, rotate
the multiplier in the opposite direction. This operation must
be carried out with great caution to prevent any damage to
things and/or people.
CAUTION : Do not exceed the MAX input value.
Inside the torque limiting socket (A) there is a fixing screw.
To release the socket and extract it, release the screw to
half stroke. To lock it instead it is necessary to tighten this
screw clockwise until the end of the stroke.
To tighten, use impact sockets only, according to the MAX
torque values applicable to the individual sockets.
While using any extension bars, it is recommended that
the multiplier should be perfectly aligned while tightening;
extension bars exceeding 250 mm in length should not be
used.
Max out 1500Nm - Max in 395 Nm
Max out 2700Nm - Max in 710 Nm
□ ½" ■ ¾"
□ ¾" ■ 1"
EN I