LD Systems STINGER MIX G3 Serie Bedienungsanleitung Seite 6

7
LOW CH1–CH3
Low-frequency equalizer (80 Hz) for input channels 1–3 (CH1–CH3). Turn anti-clockwise to reduce and clockwise to increase bass frequencies.
The equalizer is inactive in the centre detent position.
8
LEVEL CH1–CH3
Volume control for channels 1–3 (CH1–CH3). Turn anti-clockwise to reduce volume and clockwise to increase volume.
9
LINE INPUT CH4/5
Balanced line-inputs with XLR/TRS combo jacks to connect a playback device (such as a keyboard or MP3 player).
10
LEVEL CH4/5
Volume control for the stereo channel 4/5 (CH4/5). Turn anti-clockwise to reduce volume and clockwise to increase volume.
11
LINE INPUT
Stereo line input with 3.5 mm jack socket for an MP3 player or other playback device. The LINE INPUT and Bluetooth
be used simultaneously. Adjust the volume balance on the playback devices.
12
LEVEL LINE INPUT/BLUETOOTH
Volume control for the line input and the Bluetooth unit. Turn anti-clockwise to reduce and clockwise to increase volume.
13
BLUETOOTH®/HOLD TO LINK
The mixer of the LD MIX102AG3 speaker is equipped with Bluetooth technology, which means that audio files from another Bluetooth playback
device (e.g. Smartphone, tablet) can be played back on the LD MIX102AG3 speaker (maximum distance between the two devices is approx. 10
metres). If no Bluetooth playback device is connected to the internal Bluetooth unit, the blue Bluetooth LED flashes every 5 seconds. During pairing,
the LED flashes rhythmically at a frequency of approximately 3 Hz. If the Bluetooth LED lights up permanently, there is a Bluetooth connection and
playback can be started. The volume is controlled via the volume control LINE INPUT/Bluetooth® (No 12), or on the playback device.
To pair and connect the internal Bluetooth unit with a Bluetooth playback device, press and hold the HOLD TO LINK button for approximately 3
seconds until the Bluetooth LED flashes rhythmically (approx. 3 Hz). Enable Bluetooth on your playback device and search on the user interface for
available devices. Select "LD MIX10AG3" and pair your Bluetooth playback device with the Bluetooth unit. Playback can now be started. To end the
connection, press and hold the HOLD TO LINK button again for about 3 seconds. If Bluetooth® is deactivated in the paired device (e.g. Smartphone,
tablet), after a short time, the Bluetooth LED will begin to flash every 5 seconds. If the maximum range between the paired device and Bluetooth unit
is exceeded (approximately 10 m), the Bluetooth LED will flash at a frequency of about 3 Hz.
14
PRESETS
Rotary control to select one of the 16 internal digital effects. All effects are listed to the right of the operating elements for the effects
processor (DSP 24-bit digital effects).
15
DFX RET
By using the effects return control, the effects signal can be mixed with the summed signal (MAIN signal).
16
MUTE
The internal effects are muted by pressing the MUTE button. The PEAK LED indicator LED will light up continuously. Press the button again
to unmute the effects and the PEAK LED will extinguish.
17
PEAK LED
The PEAK LED lights up if the input of the internal effect is overloaded (reduce DFX effect send level on channels 1 to 3), or if the internal
effects processor is muted (MUTE).
18
HIGH
High-frequency equalizer (12 kHz) for the sum channel. Turn anti-clockwise to reduce and clockwise to increase high frequencies. The
equalizer is inactive in the centre detent position.
6
®
interfaces can both
®