ASROCK A55M-DGS Handbuch Seite 23

Downloaded from www.Manualslib.com
Infrared Module Header
(5-pin IR1)
(see p.2 No. 16)
Consumer Infrared Module Header
(4-pin CIR1)
(see p.2 No. 19)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 25)
1. High Defi nition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
For Windows
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
System Panel Header
(9-pin PANEL1)
(see p.2 No. 15)
Connect the power switch, reset switch and system status indicator
on the chassis to this header according to the pin assignments below.
Note the positive and negative pins before connecting the cables.
ASRock A55M-DGS Motherboard
manuals search engine
This header supports an
IRTX
+5VSB
optional wireless transmitting
DUMMY
and receiving infrared module.
1
GND
IRRX
This header can be used to
1
connect the remote
GND
IRTX
IRRX
controller receiver.
ATX+5VSB
This is an interface for the front
GND
PRESENCE#
panel audio cable that allows
MIC_RET
OUT_RET
convenient connection and
control of audio devices.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
®
XP / XP 64-bit OS:
® TM TM
7 / 7 64-bit / Vista / Vista 64-bit OS:
This header accommodates
several system front panel
functions.
23