ASROCK A55M-DGS Handbuch Seite 22

Downloaded from www.Manualslib.com
2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors
(SATA_1: see p.2, No. 12)
(SATA_2: see p.2, No. 13)
(SATA_3: see p.2, No. 11)
(SATA_4: see p.2, No. 10)
Serial ATA (SATA)
Data Cable
(Optional)
Print Port Header
AFD#
ERROR#
(25-pin LPT1)
(see p.2 No. 17)
1
STB#
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 18)
(9-pin USB8_9)
(see p.2 No. 20)
22
manuals search engine
These four Serial ATA2
(SATA2) connectors support
SATA_4
SATA_3
SATA data cables for internal
storage devices. The current
SATA_1
SATA2 interface allows up to
3.0 Gb/s data transfer rate.
SATA_2
Either end of the SATA data
cable can be connected to the
SATA / SATA2 hard disk or the
SATA2 connector on this
motherboard.
This is an interface for print
port cable that allows
PINIT#
GND
SLIN#
convenient connection of printer
devices.
SPD7
SPD6 ACK#
SPD5
BUSY
SPD4 PE
SPD3 SLCT
SPD2
SPD1
SPD0
Besides four default USB 2.0
USB_PWR
P-7
ports on the I/O panel, there
P+7
GND
DUMMY
are two USB 2.0 headers on
this motherboard. Each USB 2.0
1
GND
P+6 header can support two USB
P-6
USB_PWR
2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
ASRock A55M-DGS Motherboard