Inserting Paper - Epson TM-U295 Bedienungsanleitung

4. Open the printer cover by
5. If there is a used ribbon,
6. Before installing the new
7. Carefully insert the ribbon
8. Push firmly on the right
9. To put the cover back on the

Inserting Paper

Note:
Do not use wrinkled or curled paper. Be sure to use roll paper that meets
the specifications.
1. Make sure a ribbon cassette is installed in the printer.
2. Turn on the printer. The POWER light comes on.
3. Press the RELEASE button. The RELEASE light comes on to show
Downloaded from www.Manualslib.com
first pressing the ridges on
the top to the left slightly
and then pulling the cover
forward, as shown in
illustration .
2
remove it by grasping the
handle and pull it straight
out, as shown by the arrow
in illustration 3 .
ribbon, check that it is not creased or twisted. Then turn the
feed knob in the direction of the arrow on the ribbon cassette to
take up any slack in the ribbon.
cassette in the printer as
shown in illustration
Notice exactly where the
ribbon must go.
side and then the left side of
the ribbon cartridge until
each side clicks into place.
printer, first align the left side of the cover; then insert the tab
on the top; then press the bottom until it clicks into place (see
illustration ).
2
that the printer is in release mode. In this mode, paper can be
inserted and removed.
manuals search engine
2
3
4
.
4
TM-U295/U295P User's Manual 7
English