Specifications; Important Hints; Used Symbols; Installation - Hameg HM8001-2 Benutzerhandbuch

specificaTions

Valid at 23 degrees C after a 30 minute warm-up
period
General
Mainframe with power supply accomodates any
2 modules. 4 BNC connectors on rear panel for external
interconnection to each module compartment
(Option HO801)
Module supply Voltages
2 x 8 V
max. 0.5 A each
AC
2 x 5 V max. 1 A each
DC
4 x 20 V max. 0.5 A each
DC
Voltages:
between 5 V and 20 V are
programmable from each
module
Polarity: optional
Power consumption per module:
max. 25 Watt
All­DC­voltages­are­electronicaly­stabilized,­floating­
and short circuit proof.
AC test voltage to chassis:
500 V
Miscellaneous
Power switch on front panel between the two modules.
Line voltage: 115/230 V at 50 - 60 Hz
Power consumption:
max. 110 Watt
Protective system: Safety class I (EN61010-1)
Operating temperature: +5 °C . . . +40 °C
Storage temperature: –20 °C . . . +70 °C
Max. relative humidity: 5% . . . 80%
(without condensation)
Size (W x H x D): 285 x 75 x 365 mm
Weight:
approx. 4 kg
Included in delivery:
Maineframe HM8001-2, Operator's manual
Optional Accessories:
HO801 BNC connectors
HZ42 19'' Rackmount kit 2RU
HZ809 Test Adapter
S p e c i f i c a t i o n s

Important hints

The operator is requested to carefully reading the
following instructions and those of the mainfra-
me HM8001-2, to avoid any operating errors and
mistakes and in order
to become acquaint with
the module.
After unpacking the module,
check for any mechanical damage
or loose parts inside. Should there be any trans-
portation damage, inform the supplier immedi-
ately and do not put the module into operation.
This plug-in module is primarily intended for use
in conjunction with the Mainframe HM8001-2.
When incorporating it into other systems, the
module­should­only­be­operated­with­the­specified­
supply voltages.

Used Symbols

ATTENTION refer to manual.
DANGER High voltage.
Protective ground (earth) terminal.

Installation

If the HM8001-2 is to be stacked with other main-
frames or HAMEG Oscilloscopes, the exact posi-
tioning is only ensured by the footrests delivered
with the instrument. These should be attached
to the top of each instrument (except the upper-
most one) using the double-sided adhesive tape
provided. Insert the footrests into the appropriate
ventilation holes on top of the lower instrument
in such a way that they correspond exactly with
the positioning of the feet on the instrument to
be stacked above. Instruments stacked in a tilted
position will now be prevented from slipping. Put
Subject to change without notice
TRIPLE POWER SUPPLY HM 8040-3
FUSE FUSE
ON/OFF
ON/OFF
OUTPUT
HAMEG
PUSH LONG
VOLTAGE CURRENT VOLTAGE CURRENT
13