Operation; Remote Control - EuroLite IR-2 Bedienungsanleitung

______________________________________________________________________________________________

6. 6. 6. 6. Operation

Remote Control

1
The remote control is supplied with a battery inserted. An insulating
foil between the battery and the battery contacts prevents the battery
from being discharged during storage. Prior to the first operation
remove the foil from the battery support on the rear side of the remote
control. Otherwise operation of the remote control is not possible.
2
When actuating a button, always hold the remote control in the
direction of the sensor. There must be visual connection between the
remote control and the sensor.
3
If the range of the remote control decreases (3
meters as a maximum), replace the battery. For
this purpose, on the rear side of the remote
control press the small bar with the groove to the
right and at the same time remove the battery support.
4
For operation, one 3 V button cell type CR 2025 is required. When
inserting, pay attention that the positive pole of the button cell shows
upwards in the support.
Danger of explosion when battery is replaced improperly. Only
replace by the same type. Please dispose of old and used
batteries properly. Batteries are hazardous waste and should not
be disposed of with regular domestic waste!
www.eurolite.de
CAUTION!
18