Mounting And Connection; Interconnecting Several Led Strips - EuroLite IR-2 Bedienungsanleitung

______________________________________________________________________________________________

5. 5. 5. 5. Mounting and Connection

1
Connect the plug of the control unit via the link connector to the input
connector at one end of the LED strip. The arrows of both plugs must
point to each other. Otherwise the LEDs do not light up.
2
Fix the control unit at a suitable place with two screws. Alternatively
use double-sided adhesive tape.
3
Fix the infrared sensor with adhesive tape so that it is capable of
receiving the control signals from the remote control without obstacles.
4
Connect the supplied power supply unit to power input at the control
unit and to a mains outlet. The LEDs light up according to the last
control program selected.

Interconnecting Several LED Strips

1
Connect the control unit to the input connector at one end of the LED
strip in the chain as described above.
2
Then connect the other end to the connector of the subsequent LED
strip.
3
Connect further LED strip in the same way. All lengths available can
be combined as desired.
4
Always make sure that the arrows on the connectors point to each
other.
5
The maximum number of LED strip that can be interconnected to one
control unit varies with the power unit you choose.
www.eurolite.de
17