Herunterladen Inhalt Inhalt Diese Seite drucken

Setup; Installation; Sound-Control; Connection With The Dimmerpacks - EuroLite SCENE SETTER 24-48 Bedienungsanleitung

48-kanal lichtsteuerung
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5. SETUP

5.1 Installation

Install the device on a plane surface.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

5.2 Sound-control

The sound-control works via the Line In socket. Connect the sound-signal from the mixer (e.g. Master 2) with
the RCA-socket on the rear panel (input sensitivity 0.1 V - 1 V).

5.3 Connection with the dimmerpacks

DMX-512:
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Building a serial DMX-chain:
Connect the DMX-output of the SCENE SETTER with the DMX-input of the nearest dimmerpack. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

6. OPERATION

After you connected the device to the mains, the DMX Scene Setter is ready for use.

Unlock program mode

Before you can start programming you need to unlock the program mode.
Press and hold the Record-button.
Press the Flash-buttons 1, 6, 6, 8 in Preset A.
Release the Record-button.
The red LED above the Record-button is lit again and the program mode is unlocked.
2 x 24 channel Preset
With the Scene Setter you can adust two different scenes in Preset A and Preset B and fade from one to
another via the master-faders.
Press the Mode Select-button, until the A Double/Preset B-LED is lit.
Push Master A-fader to maximum.
Push channel-faders in Preset A to the desired setting.
Pull the Master B-fader to maximum.
Push channel-faders in Preset B to the desired setting.
Fade from Preset B to Preset A by pushing Master A-fader and Master B-fader.
19/23
70064545X87NXS_V_1_0.DOC

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis