Step 4: Adjust The Camera - Honeywell NightHawk HCC80354 Bedienungsanleitung

3.

Step 4: Adjust the Camera

Note
1.
2.
Note
3.
Rev 1.00
Downloaded from www.Manualslib.com
Lock the camera into position using the Allen key supplied to tighten
the locking screws on the locking rings.
If necessary, adjust the camera after it is mounted firmly in
position. Any new changes to the camera position may
require further adjustment of the zoom and focus.
Loosen, but do not remove, the three security (locking) screws on
the bezel with the Allen key supplied (see
One security screw is located under the sunhood. This screw is
accessible through the sunhood by removing the small, black,
rubber plug.
Carefully pull the bezel towards you until it is clear of the camera.
The bezel and camera fit closely together and separating
them may require using a little force. Be sure to pull the
camera straight out of the bezel. After the camera starts to
slide out, the airtight seal will break and the camera then
slides out easily.
Set the bezel and camera down in a place where the tempered glass
window cannot be scratched.
Figure 2 Camera Side View
Security screws (x3)
HC82 only
Bezel
Upper locking ring
manuals search engine
Figure 2).
Ring locking screws
Camera base
Balls and
sockets for
easy swiveling
and locing
Lower locking ring
5 Document 900.0391
09/05