Adjusting The Audio Level - Ground Zero TITANIUM GZTA 5120X-II Anleitung

1 Speaker terminals
Power terminals
2
3 Satus indication
4 Cinch inputs
5 Input level controller
6 Mode switch
High Pass controller
8
(Subsonic)
9 Filter controller
Subsonic controller
10
(GZTA 5120X Channel 5)
11 Input mode switch
13 Remote control input
The amplifier automatically turns on a few seconds after you turn on your radio.
Note: Your amplifier temporarily shuts down if it gets too hot, then restarts automatically once it cools
(At about 80° / 176° F).
1. LEVEL (Min/Max): Turn fully counter- clockwise to MIN position
2. Turn the auto sound system's volume control to
3. Adjust LEVEL to a comfortable listening level.
Controls and functions
For connection of the speakers
GND -> Ground connection
REM -> Remote antenna terminal
BATT -> +12 Volt
GREEN – OK
RED – Error
Terminal for connection of the RCA wires.
To avoid failure, please use high quality RCA wires.
With this controller you can adjust the input sensitivity.
Adjust the crossover for the chosen utilization.
LPF – Only bass frequencies (below 40Hz - 4000Hz) (Channel 5: 40Hz –
250Hz) will be reproduced.
FULL – All frequencies will be reproduced.
HPF – Only middle and high frequencies over 40 Hz – 4000 Hz will be
reproduced.
Set the filter switch to „HIGH" position.
Adjust the variable HPF crossover frequency to the desired frequency using
the controller. All frequency between 40 Hz – 4000 Hz will be reproduced.
Depeding on the mode switch position, High- or Lowpassfilter can be
adjusted in a range from 40 Hz – 4000 Hz with this controller.
For adjusting the subsonic filter in a range from 10 Hz to 50 Hz.
You can chose if the 5
Cinch input 5/6 or the summation of input 1/2/3/4.
For connection of the bass remote control.
Turning on the amplifier

Adjusting the audio level

about two-third
4
th channel of GZTA 5120X should be operated with
of its full range.