Connecting Headphones - VINCENT CD-S6MK Bedienungsanleitung

Use of the digital output
This output emits the music signal as a digital S/PDIF audio signal (PCM). The connection is only requi-
red if an external D/A converter is to be used or the player is to be connected to the coaxial digital audio
input of an AV receiver or an AV preamplifier. To make the connection you need a coaxial cable with 75Ω
characteristic wave impedance and with a RCA connector on both sides, which is not supplied with the
device. Connect the connector "DIGITAL OUT COAXIAL" (16) of the device to the digital input socket of
the amplifier which is usually labelled "DIGITAL IN" or "COAXIAL". The best sound is obtained in most
cases by connection with one of the analogue outputs (15).
CD-S6MK
A set of headphones equipped with a 6.3 mm jack can be plugged into the "PHONES" socket (13) on the front
of the appliance.
All headphones with an impedance of between 32 Ohm and 600 Ohm may be used. Unsuitable headphones
with too low impedance may damage the amplifier or produce such unexpectedly loud volume that your hearing
may be damaged. The volume should be reduced (14) for safety reasons before a set of phones is connected.
Check that the power supply to your home is appropriate to the device. The required voltage and frequency can
be read on the back of the device beside the socket for the mains. If the power supply is appropriate, push the
inlet connector of the supplied mains cable firmly into socket for the mains on the back of the device. Connect
the other end of the mains cable to a mains socket.
Vincent
34
Downloaded from www.Manualslib.com
CONNECTION TO AMPLIFIER,
RECEIVER OR PREAMPLIFIER

CONNECTING HEADPHONES

CONNECTION OF THE POWER CABLE
manuals search engine
Coaxial Cable
DIGITAL INPUT
AV preamplifier,
AV receiver, converter