Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting the Dolby Prologic II delay time
Choose one of the receiver inputs except for „5.1 CH". Change the audio playback mode to „PROLOGIC"
using the „LISTEN" (3)(37) button (do not use the button „PROLOGIC" on the remote control). Press „DELAY" (42).
SDLY - -ms
These changes can only be made while audio playback modes „PROLOGIC" or „DB DIG"
(Dolby Digital) are selected.
Settings for Dolby Digital and Prologic are saved and stored separately.
If „5.1 CH INPUT" has been selected, these settings can not be changed.
A A c c t t i i o o n n
Switch on and off
Set the volume level
Select the source input
Mute the volume level
Vincent
56
Downloaded from
www.Manualslib.com
Use the „SET" buttons (38) to change the parameter for the rear (surround) speaker channels
to the calculated Dolby Prologic II value. If no input is given for a couple of seconds, the
settings mode is quit into normal operation.
OPERATING THE RECEIVER
GENERAL FUNCTIONS
B B u u t t t t o o n n ( ( s s ) )
D D e e s s c c r r i i p p t t i i o o n n
When switched off the device is internally separated from the AC power. It has
P P O O W W E E R R ( ( 1 1 ) )
no standby circuit, it is switched on and off at the front panel and not from the
remote controller. Few seconds after switching on the receiver is operational.
At the front panel: Turn the knob „MASTER VOLUME" clockwise to increase
M M A A S S T T E E R R
the volume, and counterclockwise to decrease it.
V V O O L L U U M M E E
Using remote control: Keep the „VOL+" button pressed to increase the volume.
( ( 1 1 0 0 ) )
Use the „VOL-" button to decrease it.
In the process of changing volume the display changes to indicating the
V V O O L L + + ( ( 4 4 0 0 ) )
momentary numerical value of the setting. The volume minimum appears
V V O O L L – – ( ( 4 4 0 0 ) )
at -80 dB, the maximum volume setting is 00 dB.
I I N N P P U U T T
At the front panel: Turn the „MULTI CONTROL / INPUT SELECTOR" until the
S S E E L L E E C C T T O O R R
desired input appears.
( ( 9 9 ) )
Using remote control: Shortly press the corresponding touch button to
A A U U X X 1 1
change to the desired input channel (24)(for example „CD" oder „AUX1")
A A U U X X 2 2
or use the „SET" buttons.
C C D D
5 5 . . 1 1 C C H H
The display now shows the name of the selected input channel.
O O P P T T I I C C A A L L
As a precaution, prior to changing the input channel the value of the volume
C C O O A A X X I I A A L L
setting should be reduced!
( ( 2 2 4 4 ) )
The mute function can be activated only from the remote control. It cuts off
the receiver output signal and thereby silences loudspeakers, headphones
M M U U T T E E ( ( 4 4 1 1 ) )
and the outputs "PRE" (19) and "SW" (18) of the receiver. The next push on
the button will recover the original volume. While the system is muted, the
display (2) shows "MUTE".
manuals search engine
Werbung
Inhaltsverzeichnis
Fehlerbehebung
