DJI BS60 Bedienungsanleitung Seite 5

Activation
Use DJI Pilot app and follow the instructions below to activate the Battery Station.
1. Connect the Battery Station to a power outlet and press the Power Button to turn on the
Battery Station. Connect the Battery Station to the remote controller using a USB-C cable.
2. Turn on the remote controller and run the DJI Pilot app.
3. Follow the app instructions to activate the Battery Station.
Using the Battery Station
Charging
1. Connect the Battery Station to a power outlet (100-120 Vac, 50-60 Hz / 220-240 Vac,
50-60 Hz) via the AC power cable.
a. With a 100-120 V input, it takes about 70 minutes to fully charge the TB60 battery,
and 40 minutes to charge from 20% to 90% battery level. b. With a 220-240 V input,
it takes about 60 minutes to fully charge the TB60 battery, and 30 minutes to charge
from 20% to 90% battery level.
Power Outlet
2. Press the Power Button once to turn on the Battery Station.
3. Insert the batteries into the Battery Ports to start charging.
For TB60 Intelligent Flight Batteries, the Battery Station will charge the two batteries
with the most amount of remaining battery power first. For example, if there are
four TB60 batteries plugged into the Battery Station (the first two batteries have
10% remaining battery power and the second two batteries have 30% remaining
battery power), the Battery Station will automatically charge the batteries with the
highest remaining battery power first.
For WB37 Batteries, the Battery Station will charge the battery with the highest
remaining battery power first.
When the temperature of the battery is too low, it will warm up automatically before
charging.
4 ©
2020 DJI All Rights Reserved.