Block Diagrams - Laney Rb2 Handbuch

BLOCK DIAGRAMS

RB2
INPUT
GAIN
PAD
RB3
INPUTS
NORMAL
GAIN
HI
PAD
General Notes
Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off
your equipment. With all system parts connected, turn on source equipment
BEFORE turning on your
damage to your speakers. By turning on your
transients from other equipment will not reach your loudspeakers Wait until all system parts have stabilised usually a couple
of seconds Similarly when turning off your system always turn down the .
turn off its power before turning off other equipment.
Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.
9
ON
COMPRESSOR
EQ SECTION
SECTION
CLIP DISTORTION
LIMITER
ON ACTIVE
COMPRESSOR
EQ SECTION
SECTION
CLIP DISTORTION
LIMITER
Bass A mplifier Many products have large transient surges at turn on and off which can cause .
Bass A mplifier LAST and making sure its
D.I.
AUX IN (3.5MM)
VOLUME
D.I. D.I. AUX IN (3.5MM)
FX LOOP
SEND RETURN
VOLUME
This loop is a series type so all
your signal will go through your
FX unit.
: CD players, mixers, effects processors etc.
Volume
.
Volume control on your
HEADPHONES (3.5MM)
LOUDSPEAKER
POWER
AMP
HEADPHONES (3.5MM)
LOUDSPEAKER
POWER
AMP
control is set to minimum any
;
Bass Amplifier and then