Heatsail DOME Pendant Betriebsanleitung Seite 42

EN
Reprogramming the remote:
Open the controle box and locate the dimmer/switch module.
(1) Switch on the main power
(2) Be aware of any exposed wiring
(3) Find the "Learning Key" on the dimmer/switch module
Min.Set
max.
400W AC 100-240V
L
Register transmitter with the receiver
(1) Press the "Learning Key" for one second. The search mode will be active
for a short period. Use the dim for the light and the switches for the heating.
(2) Send a signal to the receiver with the remote by clicking one of the buttons
on the remote control. If this is first use of the DOME Pendant, please be
sure that the protective film on the battery of the remote is removed.
(3) The receiver will store the applicable transmission code in the receivers
memory. If the device successfully paired with the remote, the light of the
DOME Pendant will light up briefly (1-2 seconds).
Repeat this procedure to register several remotes, if required. The receiver
can store up to eight transmission codes in its memory. The memory will be
retained if you install the receiver somewhere else or if the power goes off.
42
A1-A2: 8-230V
Learning
Key
N
L N N
L
Light
Power off
Brightness down
25% Brightness
75% Brightness
Heating zone 1
Not used
Light
Power on
Brightness up
50% Brightness
100% Brightness
H1 H2 Heating zone 2
Not used
NOTE: Before first use, please
open the battery cover of the
remote and remove the
protective film on the battery
still present.
Top view
Top view
Heatsail DOME® PENDANT