Heatsail DOME Pendant Betriebsanleitung Seite 29

EN
3.2. Replacing the lamp
Your DOME Pendant is supplied with a R7S 230V/120 Watt (78mm) halogen
bulb as standard. The maximum permitted output power of the bulb is 120
Watt.
The electrical supply must be disconnected via the installation's breaker
switch before the bulb can be replaced.
You can replace the bulb by carefully sliding the glass upwards. Use a
tool (like a screwdriver) to hold up the glass. The bulb is held in place by a
spring. Remove the bulb by first pushing it to the left or right and thereby
releasing it from its socket. Then replace the bulb and reverse previous
steps. Please be careful never to touch the halogen bulb with bare fingers,
as oils from skin will significantly reduce bulb life.
3.3. Inspection
The DOME Pendant must be subjected to an annual inspection.
The user is not authorized to carry out his own inspections and repairs.
Inspection of the DOME Pendant must exclusively be carried out by
qualified and authorized technicians, in accordance with Heatsail's
applicable standards and regulations. "Qualified technicians" are
understood to mean: people who have completed a technical training
course for the installation of outdoor heating and who are familiar with the
applicable electrical laws and regulations.
The electrical supply must be disconnected via the installation's mains
breaker before any work can be carried out.
All repairs must be requested via an authorized distributor of Heatsail
products. A repair is only valid when original parts have been used.
Upon written approval by Heatsail, the entire control panel should be
returned in case of a defective cable.
Heatsail will not be held responsible for damage resulting from non-
compliance with the maintenance instructions.
User manual 29