Installation; Unpacking; Electrical Connection - Franke CRYSTAL FMW 45 CR C Installations- Und Gebrauchsanweisung

INSTALLATION

Unpacking

X X
When you receive the appliance, unpack it
or have it unpacked immediately.
X X
Check its general appearance.
X X
Make a note of any reservations on the
delivery slip and keep a copy.
X X
Remove all protective packing.
X X
Check and follow the appliance's
specifications which are listed on the
data plate.
Choice of location and fitting
This appliance can be installed in a cabinet
column as shown in the images below.
Z X
Do not use your appliance immediately (wait
approximately 1 to 2 hours) after transferring
it from a cold place to a warm place, as
condensation may cause a malfunction.
Z X
Centre the oven in the cabinet so as to ensure
a minimum distance of 10 mm between the
appliance and the surrounding unit.
Z X
The material of the cabinet supporting
the appliance must be heat resistant (or
covered with a heat-resistant material).
Z X
For greater stability, attach the oven to
the unit with 2 screws through the holes
provided on the side panels.
FMW 45 CR C XS / FMW 45 CR C BK

Electrical connection

by installers and qualified technicians.
Z
Z
Z
Z
Z
Z
home requires a modification to connect the
appliance, call a qualified electrician.
During maintenance, the appliance must be
disconnected from the mains, the fuses must
be switched off or removed.
– 11 –
Installation should only be performed
X
The appliance must be recess-fitted
correctly to ensure electrical safety.
X
The electrical connections should be made
before the appliance is installed in its
housing.
X
Ensure that the circuit has sufficient power
(16 Amps).
X
The safety wire (green-yellow) is connected
to the appliance's ground terminal and
must be connected to the installation's
earth.
X
If the oven malfunctions in any way, unplug
it or remove the fuse for the circuit where
the oven is installed.
X
We cannot accept liability for any accident
or incident resulting from non-existent,
defective or incorrect grounding.
If the electrical installation of your
600 ext.
550 int.
560
18
EN
547
22
x 2
592