Powering/Charging The Cartrek400 Gps; Recharging - CarTrek 400 Gebrauchsanweisung

B
C
. The angle of the mounting bracket can be
adjusted by slackening the adjuster knob on
the mounting bracket. Once you have adjusted
the bracket re-tighten the adjuster knob.
(figure D)
D
NOTE: Some vehicles may have a heat
reflective windscreen that can prevent GPS
signals reaching the satellite navigation
system.
GETTING STARTED
If your vehicle is fitted with a heat
reflective windscreen you may need to use an
external antenna.
• When using the in-vehicle bracket,do not
install in a location that will block the view of
the driver.
• Recommended installation requirements:
The bracket base should be secure close to
the area above the dashboard to prevent
excessive shock.
. Powering/Charging the
CarTrek00 GPS
To power the GPS unit from a vehicles
auxiliary socket plug one end of the 12V
power cable into the d.c.socket on the rear of
the satellite navigation unit and the other end
into the vehicle auxiliary socket. If using the
GPS unit in the car we recommend you use
the 12V car accessory adaptor in order to
maintain the battery level.

. Recharging

Plug one end of the 12v power cable into the
d.c. socket on the rear of the satellite
navigation unit and the other end into the
vehicle auxiliary socket. When charging the
battery for the first time charge the battery for
5 hours, subsequent charges will be shorter.
9