Installing And Removing The Sd Memory Card; Flexible Mounting Arm Using The In-Vehicle Bracket - CarTrek 400 Gebrauchsanweisung

1. Installing and removing the
SD memory card
The SD memory card contains the map data
required by the GPS. Slot the card into the
memory card slot located on the right hand
side of the unit make sure the contacts on the
card point towards the front of the GPS unit.
To remove the SD memory card press lightly
on the top edge until it ejects. Remove the
card taking care not to touch the contacts.
Memory cards are very fragile take care not to
force the card or touch the contacts.
The included memory card contains the
digital map files that are required for the GPS
navigational data.do not delete.
• When removing the memory card, pleasemake
sure the card is not reading data, or it will
cause a system crash.
• Please do not set the SD memory card
as write protect, or the system cannot be
successfully executed.
• When operating, accidental removal of the
memory card will result in an error message,
please reinsert the memory card and reset
the unit.

GETTING STARTED
. Flexible mounting arm (using the
in-vehicle bracket)
The included in-vehicle bracket set can be
suctioned securely on the front windscreen,
this device will effectively secure the
CarTrek400 GPS unit to the vehicles winds-
creen. Follow the procedures below to secure
the bracket.
1. Place the CarTrek400 satellite
navigation system onto the mounting bracket
aligning the slots on the underside of the
CarTrek400 unit with the lugs on the
mounting bracket. (figure A)
. Slide the unit back until you hear a click.
The CarTrek400 satellite navigation unit is
now locked into place. (figure A)
A
. Ensure the windscreen of the vehicle is dust
and grease free. Place the mounting bracket
onto the windscreen in a suitable position,
push the plastic lever forward to secure the
mounting bracket to the windscreen. (figure
B+C)