Environmental Protection - Worx WX426 Originalbetriebsanleitung

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece.
ASSEMBLY AND OPERATION
Action
Saw blade Assembly and
Removing
Safety On/Off Switch
Cross And Rip Cutting
Cutting Depth Adjusting
Using the laser light feature
Replacing laser batteries
Parallel Guide
Pocket Cutting
Sawdust Removal
14
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance
and cutting quality depend essentially on the
condition and the tooth count of the saw blade.
Therefore, use only sharp saw blades that are suited
for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
Only use saw blades recommended.
MAINTAIN TOOLS WITH
CARE
Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
Electric Circular Saw
Figure
See Fig. A
See Fig. B
See Fig. C1, C2
See Fig. D1, D2
See Fig. E
See Fig. F1-F3
See Fig. G1 G2
See Fig. H1 H2
See Fig. I
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water
or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Periodically clear dust and chips from guard and
base to ensure proper performance.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
TROUBLE SHOOTING
Possible
Symptom
Causes
Power cord
Tool will not plugged
not start in.
when Power cord
operating is broken.
the on/off Carbon
switch. brush has
worn down
Cutting Sawdust
depth is accumulated
less than at the rear of
that is set. the base.
Blade is
Blade not tightly
spins or engaged
slips with the
spindle.
Blade is dull.
Blade is not
Blade will
mounted
not cut a
properly.
straight
Saw is not
line.
being guided
properly.
Blade kicks
Blade is not
back when
spinning fast
beginning
enough
a cut
Possible Solution
Check to make sure
power cord is connected
well into a working
outlet.
Unplug the power
cord. Replace it using a
qualified maintenance
person.
Replace the carbon
brush using a qualified
maintenance person.
Shake out sawdust.
Consider connecting
a vacuum for dust
collection.
Remove the blade,
and reassemble it
as described in Saw
blade Assembly and
Removing section.
Mount a new, sharp
blade on the saw.
Check that blade is
properly mounted.
Use a parallel guide.
Allow the saw blade to
reach full speed prior to
beginning a cut in the
material.
EN