Thermia MBH Calibra 200 Installationsanleitung Seite 19

Installation Guide
If Thermia MBH Inverter Design is installed in combination with Diplomat Duo Inverter, the sensors (PT 1000 type) on the water tank
must be connected to the following terminal blocks (X2):
• Hot water – 16-17
• Top sensor – 18-19
If Thermia MBH Inverter Mini Design is installed in combination with Diplomat Duo Inverter Mini, the sensors (PT 1000 type) on the water
tank must be connected to the following positions on the PCB in the heat pump:
• Hot water – Y605 (Mid)
• Top sensor – Y605 (Top)
If Thermia MBH Calibra is installed, the sensors (PT 1000 type) on the water tank must be connected to the following positions on the
PCB in the heat pump:
• Hot water – T37 (Lower)
• Top sensor – T36 (Top)
3.2.4 Installation carried out by:
Pipe installation:
Date . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Company . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Name . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Tel. No . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electrical installation:
Date . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Company . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Name . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Thermia AB
MBH
086L5801 rev 2
19