Setting Up Your Camera; Install The Battery; Charge The Battery - HP Photosmart R827 Bedienungsanleitung

2
Setting up your
camera

Install the battery

1. Open the Battery/Memory card
door by sliding the door latch as
indicated on the Battery/Memory
card door.
2. Insert the battery in the larger slot,
pushing the battery in until the
latch catches.
3. Close the Battery/Memory card
door.
Note Turn the camera off before removing the battery.
Fully charge the battery before using it the first time.

Charge the battery

You can charge the battery in
the camera, using the AC
adapter.
1. Plug the small end of the
power cord into the AC
power adapter, and the
large end into an electrical
outlet.
2. Attach the thin cord from the AC power adapter to
the camera as shown.
The camera's blinking Battery Charging light indicates
that the battery is charging; the battery is fully charged
when the light stays on solid (approximately 2–3 hours).

Setting up your camera

9