Troubleshooting - Bosch Sensixx'x DA70 Gebrauchsanleitung

Trouble shooting
Problem Probable cause
The iron does not 1. Temperature control (12) set to
heat up.
2. The "SensorSecure" system has been
The "TempOK" 1. The soleplate (7) is heating up or
lights inside the
temperature
control (12) flash.
The clothes tend 1. The temperature is too high.
to stick
Water drips out of 1. Temperature control (12) setting is too
the soleplate (7)
together with
steam.
2. Steam regulator (3) is set too high in
3. You have pressed the shot of steam
Steam does not
1. Steam regulator (3) is set to
come out.
2. The temperature is too low. Anti-drip
Smoke comes out
1. This may be caused by the lubrication
when connecting
the iron for the first
time.
Excessive dripping 1. No proper closing of "Calc'nClean"
or steaming.
Deposits come out 1. Traces of lime scale are coming out of
through the holes
in the soleplate
(7).
If none of the above solves the problem, get in touch with an authorised technical service.
* Model dependent
minimum.
activated. The iron is set to stand-by.
cooling down to the selected
temperature.
low.
conjunction with a low temperature.
button (2) repeatedly without waiting
for 5 seconds between each press.
position.
system is activated.
of some of the internal parts.
system.
the steam chamber.
Solution
1. Turn to a higher position.
2. Grip the handle of the iron to re-start
it.
1. This is normal and lights will stop
flashing when the selected
temperature is reached.
1. Turn the temperature control (12)
down and wait until the iron has
cooled down.
1. Turn the temperature control (12) to a
higher setting and wait until the
"TempOK" lights inside the
temperature control stop flashing and
remain lit continuously.
2. Set the steam regulator (3) to a lower
setting.
3. Wait 5 seconds between each press
of the shot of steam button.
1. Set the steam regulator to a higher
position.
2. Set to a higher temperature if
compatible with the fabric.
1. This is normal and will stop after a
few minutes.
1. Actuate a few times the "clean"
button (10).
1. Carry out a cleaning cycle
(see "Calc'nClean" section).
19
BOS CH