Operation; Specifications - Skytec SPL EQ BT Serie Gebrauchsanleitung

Rear Panel

OPERATION

1. Connect loudspeaker system (MINIMUM load 4 ohms) with sufficient handling capacity to the output terminals of the
amplifier.
2. Connect output from television, dvd player, computer, mixer or any other suitable signal source to the appropriate input
sockets of the power amplifier. On the front panel you can connect your MP3 player with a 3.5mm stereo jack
connection lead.
3. Connect the power cord to the mains.
Select the correct source with the selector on the front. (PC – MP3 – TV – CD)
4.
5. Turn gain controls to minimum , switch on the amplifier.
6. Adjust the volume controls to required level. NOTE. If the audio input signal is too high, distortion will result and the
CLIP indicator will light. If the clip LED is lit permanently or flashes, the level should be reduced.
7. Use the equalisers to make adjustments to the sound. They can compensate for sound quality differences in the source
material, or differences in room acoustics. Each EQ has his own boost or cut for the low, mid & high frequencies
.
For reliable and trouble free operation, please observe the following points:

Ensure all input / output connections are correct and secure.

The handling capacity of the loudspeakers is adequate for the output of the amplifier.

Always site the amplifier in a well ventilated location

Protect unit from severe shocks

Do not plug in or unplug the speakers during the operation of the amplifier. This would seriously damage the
amplifier.

SPECIFICATIONS

Max Output Power @ 4 Ohm
Max Output Power @ 8 Ohm
Load Impedance minimum
Input
Connectors
Output
Input Sensitivity
Input Impedance
Frequency Response
THD +N
Signal to Noise Ratio.
Cross-talk
Indicators
Mains Power
Fuses
Dimension(W X D X H)
Weight
SPL–EQ BT SERIES
SPL 500EQ BT
2x 250W
2x 200W
6x RCA (phono) socket & 3.5mm Stereo Jack
Speaker terminal board
20 Hz - 20 KHz ±3 dB
Clip / Signal / Power
220~240 Vac(Euro) / 50 Hz
T1A T2A
482 X 290 X 88mm
3,5kg 4,2kg
- 4 -
1. Inputs Channel A & B (
RCA phono sockets)
2. Channel A & B output
3.
Mains input power & fuse
holder
4.
Fan only models from
SP700EQ
SPL 700EQ BT
2x 350W
2x 250W
4 Ohm
775 mV
10 K min.
 

 
SPL 1000EQ BT
2x 350W
T4A
4,8kg