Operation - Skytec SPL500MP3 Gebrauchsanleitung

LAYOUT

OPERATION

1. Connect loudspeaker system (MINIMUM load 4 ohms) with sufficient handling capacity to the output terminals of the
amplifier.
2. Connect output from television, dvd player, computer, mixer or any other suitable signal source to the appropriate input
sockets of the power amplifier. On the front panel you can connect your CD player with a 3.5mm stereo jack connection
lead. On the front panel of the amplifier is a MP3 control panel having USB/SDmmc inputs. The amplifier is
supplied with a remote control with which the MP3 panel can be controlled too, as well as the built-in
equalizer.
3. Connect the power cord to the mains.
4. Select the correct source with the selector on the front. (PC – MP3 – TV – CD)
5. Turn gain controls to minimum , switch on the amplifier.
6. Adjust the volume controls to required level. NOTE. If the audio input signal is too high, distortion will result and the
CLIP indicator will light. If the clip LED is lit permanently or flashes, the level should be reduced.
7. Use the equalisers to make adjustments to the sound. They can compensate for sound quality differences in the source
material, or differences in room acoustics. Each EQ has his own boost or cut for the low, mid & high frequencies
.
For reliable and trouble free operation, please observe the following points:
Ensure all input / output connections are correct and secure.
•
The handling capacity of the loudspeakers is adequate for the output of the amplifier.
•
Always site the amplifier in a well ventilated location
•
Protect unit from severe shocks
•
Do not plug in or unplug the speakers during the operation of the amplifier. This would seriously damage the
•
amplifier.
SPL–EQ SERIES
6 3 4
7 5
4 3 2
1
- 4 -
Front Panel
1. Power switch
2. Power on/off indicator
3. Channel A & B volume
control
4. Signal LED Channel A & B
5. Clip indicator
6. Input selector
7. MP3 Input
Rear Panel
1. Inputs Channel A & B (
RCA phono sockets)
2. Channel A & B output
3.
Mains input power & fuse
holder
4.
Fan only on SP700EQ &
SPL100EQ