Werbung
Protect our environment: do not dispose of electrical equipment in the domestic waste.
Please return any electrical equipment that you will no longer use to the collection points
provided for their disposal.
This helps avoid the potential effects of incorrect disposal on the environment and human
health.
This will contribute to the recycling and other forms of reutilisation of electrical and
electronic equipment.
Information concerning where the equipment can be disposed of can be obtained from your
local authority.
Protégeons notre environnement Les appareils électriques doivent être recyclées
conformément à la loi en vigueur.
Rendre les appareils électriques non utilisés à des centres de récolte des déchets prévus à
cet effet.
Ceci permet d'éviter les effets néfastes de ce type déchets sur l'environnement et sur la
santé de l'homme.
Ceci contribue au recyclage ou à toute autre forme de réutilisation des
appareils électriques et électroniques.
Pour plus d'informations, veuillez contacter les autorités compétentes en la matière.
QUICK START GUIDE
1. Fit the Batteries into the Remote Control according to the diagram
in the battery compartment.
2. Plug your main home aerial into the TV set.
3. Plug your TV into the mains and switch ON using the
on the front panel. If your TV screen does not light up, press the
P+, P- key or any number key on the hand unit to cancel standby
mode.
4. On your hand unit press the MENU key 2 times. The Install menu
will appear on the screen.
5. On your hand unit press the OK key. Your TV will now automatically
tune and store your local TV stations. This may take a few minutes.
On completion, some units automatically show the Organize menu
for checking, labeling and moving the programmes: see
" Customise your stored programmes" on page 8, or leave it for
later. To turn off the Organize menu for now and view the full
picture, press the MENU key twice.
6. Select a programme using the P+ and P- keys or the number keys.
! WARNING !
7.If you will forget lock code or dial it wrongly, press remote control key
PP 3 times. You should change code or disable the lock after TV will
switch on ( look 9p. ).
Refer to the instruction booklet for further information about the many
other facilities.
Note:
When there is no signal in the aerial socket, the screen of TV is blue.
0
button
3
Werbung
Kapitel
